Unique Speedometer Drive Unit Solution?

Moto Rumi technical problems or solutions
Post Reply
Ian Skinner
Posts: 524
Joined: Mon Aug 24, 2009 12:36 pm
Location: South Wales UK

Unique Speedometer Drive Unit Solution?

Post by Ian Skinner » Mon Jun 20, 2016 7:59 pm

While rummaging through my Rumi stuff over the weekend, I came across a very interesting Formi speedometer drive. It has obviously been made by an excellent engineer. It appears to me, to be a full renovation of an existing unit, where the original main body casing had collapsed. (I’ve seen quite a few in that state). The main body is turned from 2 inch diameter brass stock and the output drive housing from ½ inch diameter brass stock. Those two components are skilfully silver soldered together. Incorporated, is a hardened steel core ring for the axle nuts to pull up on. All the other components worm wheel, drive gear, drive plate and the fore and aft drive gear bearings appear to be originals from the damaged unit.

An idea comes to mind; as replacement drive units are very rare, perhaps an enterprising engineer among us could take this 1960’s idea forward?? Who knows?

Ian
Attachments
000_0764e.jpg
000_0764e.jpg (36.86 KiB) Viewed 3567 times
000_0763e.jpg
000_0763e.jpg (33.01 KiB) Viewed 3567 times
000_0765e.jpg
000_0765e.jpg (26.54 KiB) Viewed 3567 times
000_0767e.jpg
000_0767e.jpg (34.89 KiB) Viewed 3567 times

Post Reply