Page 1 of 1

gear selector problems

Posted: Sun Nov 10, 2019 3:11 pm
by Izydizy
I have reassembled the gearbox and the gears seem to select ok with the top crankcase cover replaced but when I add the adjacent cog - see red arrow nothing moves and when I add the cover the whole thing is locked up. Is there a special way of replacing this cover so that the selector moves through the full range? do the marks on this cog have significance?

rumi selector1.jpg
rumi selector1.jpg (160.16 KiB) Viewed 1170 times
rumi selector.jpg
rumi selector.jpg (195.77 KiB) Viewed 1170 times

Re: gear selector problems

Posted: Sun Nov 10, 2019 5:35 pm
by hugomez
Hi Izydizy,

Have a look to the next topics:

https://formichino.com/forum/viewtopic.php?t=1042

https://formichino.com/forum/viewtopic.php?t=126

https://formichino.com/forum/viewtopic.php?t=528

https://formichino.com/forum/viewtopic. ... &start=225
(in this last link start reading from my reply posted on "Monday May 21, 2012 2:23 pm")

There are so many other topic in the forum talking about that subject, but with the information you will find so far in those three topics, you may clarify your doubts. If you still have doubts after that, please don't hesitate to ask again here.

Good luck!